|
|
Block of Flats
Jánská, Kamila ; Lavická, Radomila (referee) ; Lavický, Miloš (advisor)
Diploma thesis describes the design and processing of project documentation of the apartment building. The apartment building is located in the central part of the city of Brno, in the district of Štýřice. The building has 5 floors. Its basementless with flat roof and it is based on the footings of plain concrete. Load-bearing, peripheral walls and partitions are designed from ceramic blocks POROTHERM. Ceiling construction is designed to be assembled of ceramic ceiling fittings MIAKO built on POT supports. Peripheral walls of all floors are insulated with external thermal insulation composite system ETICS with thermal insulation of mineral wool. In the place of the plinth is wool replaced by XPS polystyrene. In the facade there are anchored wooden lattice constructions using ProPasiv anchors. These constructions are covered by façade cladding sheets CEMBRIT METRO and they devide whole building into separate units. There is housing and communal part of the building. On the first floor there are storage areas, the main service room, utility room and two barrier-free apartments. In the second to the fifth floor there are 9 residential units, one of which is designed as duplex apartment . All floors are connected by staircase and wheelchair lift. Parking for 17 cars is designed in front of the building . Two parking spaces are wheelchair accessible.
|
|
|
University College in Olomouc
Šlézarová, Markéta ; Kalánek, Jiří (referee) ; Čupr, Karel (advisor)
Project documentation is about a university college and commercial facilities. It is a detached building, built in close proximity to the University of Economics in Olomouc. The building has five floors. The first floor is used for commercial purposes and another four floors for student accommodation. Roof is flat. The structural system consists of reinforced concrete columns and beams and bricks Ytong. Ceilings are reinforced concrete slabs. The roof is a single casing. The construction is based on reinforced concrete footings and the walls are passports.
|
|
|
Mixed-use building in Brno
Kopecký, Lukáš ; Mizerová,, Lenka (referee) ; Smolka, Radim (advisor)
This thesis describes the design and processing of project documentation multifunctional house. The multifunctional building is located in the central part of the city of Brno, in the district of Štýřice. This is a five-storey, basementless building with a flat roof on two levels. The building is based on foundations made of plain concrete. Supporting, peripheral and partition walls are designed from ceramic blocks POROTHERM. Ceiling construction is designed to be assembled of ceramic ceiling fittings MIAKO stored on POT beams. External walls of all floors are insulated using an external ETICS with thermal insulation made of mineral wool, which is replaced by XPS polystyrene used for plinth. Part of the facade is designed as ventilated, consisting of trusses of wood and sheathed by cladding panels CEMBRIT METRO. This architecturally divide the building into separate units. The building includes parts of the administrative, residential parts and parts for business purposes. On the first floor there are areas of common storage area of the apartment house, the main utility room, utility room. Furthermore, there is an administrative part, where are the reception facilities for reception, sanitary facilities for employees and office work. Part of the first floor is also a small shop with warehouse and facilities for employees. The second floor is a residential unit and the second part of the administrative unit. Third to the fifth floor is only residential and there are 6 residential units. All floors are connected by staircase and a wheelchair lift. In front of the building is designed parking lot for 20 cars. One of the parking space is wheelchair accessible.
|
|
|
Hotel Aztec
Beránek, Tomáš ; Spáčilová, Jitka (referee) ; Sukopová, Dáša (advisor)
The aim of the thesis was to design a building named Hotel Aztec. The building will serve for accommodation and recreation. The restaurant is also part of the hotel. There is a car park near the hotel building. The hotel has four floors and basement. There are 26 suites, 2 of them are three bed rooms, 20 double or twin rooms and 4 single rooms. The south-facing orientation of the suites ensures sufficient insolation. In ground floor there is one twin room for disabled persons. In ground floor there is restaurant with kitchen connected with bar in basement. There is also wellness centre, mechanical rooms and storages. On the northeast side of the hotel there are offices and rooms for employees and training room. The loadbearing masonry is from sand-lime blocks and there are cast-in-place reinforced concrete slabs and concrete foundations. The external wall is insulated with ETICS. All roofs are warm flat, over the restaurant there is intensive green roof, The roof over the 2nd floor is walkable - roof terrace. Over the 3rd floor there is non-walkable flat roof. The building is heated by heat pumps and there is mechanical ventilation with heat recovery.
|
|
|
First Step in Living
Čapek, Aleš ; Závorková, Kateřina (referee) ; Králová, Zuzana (advisor)
To my master's thesis I approached with the idea of functional simplicity in construction and without limitation of comfort of the object´s users. Residential house is located in a new development in Pávov near Jihlava, which is designed as a five-storey building that provides housing for people moving for work. This is why I designed it as a low cost construction, which mainly consists of one room apartments with a kitchen corner. The whole building is shaped as "L", where the ground floor serves as technical facility of the object, entrance, cellar and a covered parking space.The following four floors serve as residential. From the construction point of view I chose a suitable combination of materials and systems for overall pleasant use of the building.
|
|
|
Hotel Aztec
Beránek, Tomáš ; Spáčilová, Jitka (referee) ; Sukopová, Dáša (advisor)
The aim of the thesis was to design a building named Hotel Aztec. The building will serve for accommodation and recreation. The restaurant is also part of the hotel. There is a car park near the hotel building. The hotel has four floors and basement. There are 26 suites, 2 of them are three bed rooms, 20 double or twin rooms and 4 single rooms. The south-facing orientation of the suites ensures sufficient insolation. In ground floor there is one twin room for disabled persons. In ground floor there is restaurant with kitchen connected with bar in basement. There is also wellness centre, mechanical rooms and storages. On the northeast side of the hotel there are offices and rooms for employees and training room. The loadbearing masonry is from sand-lime blocks and there are cast-in-place reinforced concrete slabs and concrete foundations. The external wall is insulated with ETICS. All roofs are warm flat, over the restaurant there is intensive green roof, The roof over the 2nd floor is walkable - roof terrace. Over the 3rd floor there is non-walkable flat roof. The building is heated by heat pumps and there is mechanical ventilation with heat recovery.
|
|
|
Mixed-use building in Brno
Kopecký, Lukáš ; Mizerová,, Lenka (referee) ; Smolka, Radim (advisor)
This thesis describes the design and processing of project documentation multifunctional house. The multifunctional building is located in the central part of the city of Brno, in the district of Štýřice. This is a five-storey, basementless building with a flat roof on two levels. The building is based on foundations made of plain concrete. Supporting, peripheral and partition walls are designed from ceramic blocks POROTHERM. Ceiling construction is designed to be assembled of ceramic ceiling fittings MIAKO stored on POT beams. External walls of all floors are insulated using an external ETICS with thermal insulation made of mineral wool, which is replaced by XPS polystyrene used for plinth. Part of the facade is designed as ventilated, consisting of trusses of wood and sheathed by cladding panels CEMBRIT METRO. This architecturally divide the building into separate units. The building includes parts of the administrative, residential parts and parts for business purposes. On the first floor there are areas of common storage area of the apartment house, the main utility room, utility room. Furthermore, there is an administrative part, where are the reception facilities for reception, sanitary facilities for employees and office work. Part of the first floor is also a small shop with warehouse and facilities for employees. The second floor is a residential unit and the second part of the administrative unit. Third to the fifth floor is only residential and there are 6 residential units. All floors are connected by staircase and a wheelchair lift. In front of the building is designed parking lot for 20 cars. One of the parking space is wheelchair accessible.
|
|
|
Block of Flats
Jánská, Kamila ; Lavická, Radomila (referee) ; Lavický, Miloš (advisor)
Diploma thesis describes the design and processing of project documentation of the apartment building. The apartment building is located in the central part of the city of Brno, in the district of Štýřice. The building has 5 floors. Its basementless with flat roof and it is based on the footings of plain concrete. Load-bearing, peripheral walls and partitions are designed from ceramic blocks POROTHERM. Ceiling construction is designed to be assembled of ceramic ceiling fittings MIAKO built on POT supports. Peripheral walls of all floors are insulated with external thermal insulation composite system ETICS with thermal insulation of mineral wool. In the place of the plinth is wool replaced by XPS polystyrene. In the facade there are anchored wooden lattice constructions using ProPasiv anchors. These constructions are covered by façade cladding sheets CEMBRIT METRO and they devide whole building into separate units. There is housing and communal part of the building. On the first floor there are storage areas, the main service room, utility room and two barrier-free apartments. In the second to the fifth floor there are 9 residential units, one of which is designed as duplex apartment . All floors are connected by staircase and wheelchair lift. Parking for 17 cars is designed in front of the building . Two parking spaces are wheelchair accessible.
|
|
|
University College in Olomouc
Šlézarová, Markéta ; Kalánek, Jiří (referee) ; Čupr, Karel (advisor)
Project documentation is about a university college and commercial facilities. It is a detached building, built in close proximity to the University of Economics in Olomouc. The building has five floors. The first floor is used for commercial purposes and another four floors for student accommodation. Roof is flat. The structural system consists of reinforced concrete columns and beams and bricks Ytong. Ceilings are reinforced concrete slabs. The roof is a single casing. The construction is based on reinforced concrete footings and the walls are passports.
|
|
|
First Step in Living
Čapek, Aleš ; Závorková, Kateřina (referee) ; Králová, Zuzana (advisor)
To my master's thesis I approached with the idea of functional simplicity in construction and without limitation of comfort of the object´s users. Residential house is located in a new development in Pávov near Jihlava, which is designed as a five-storey building that provides housing for people moving for work. This is why I designed it as a low cost construction, which mainly consists of one room apartments with a kitchen corner. The whole building is shaped as "L", where the ground floor serves as technical facility of the object, entrance, cellar and a covered parking space.The following four floors serve as residential. From the construction point of view I chose a suitable combination of materials and systems for overall pleasant use of the building.
|
guest ::
